MPM MCZ-112 Bedienungsanleitung Seite 19

PREPARATION FOR USE
In order to remove factory deposits, protective films, etc. that may be present on a brand
new device, fill the kettle with water to the maximum level, boil the water and then rinse
the device. This operation should be repeated at least 5 times, by proceeding as described
below.
USING THE KETTLE
1. Remove the kettle from the power base (6) before filling with water.
2. Press the lid opening button (3) to open the lid and fill the kettle up to the desired level (no less
than 0.5 l and no more than 1.7 l). Close the lid carefully (2).
3. Put the kettle on the power base (6). Turn on the kettle with the On/Off switch (5). When the
water starts boiling, the kettle will turn off itself. You can always turn it off sooner with the On/
Off switch.
4. Once the water has boiled or the kettle has been turned off with the On/Off switch, wait for
15 to 20 seconds before turning on the kettle again. If the kettle is turned on without any water
in it, the overtemperature safety will turn off the kettle. If this happens, put the kettle away to
cool down for 15 minutes before filling with water.
CLEANING AND MAINTENANCE
Clean the kettle frequently of limescale. Use limescale removing chemicals dedicated to electric
kettles (and use the instructions for use of the chemical) or a mixture of water with vinegar or citric
acid. Failure to descale the kettle may result in its failure. Wipe the kettle clean inside and out with
a cloth. Do not clean with a wire brush, scouring pads or strong detergents.
TECHNICAL SPECIFICATION
See the product's nameplate for technical specifications.
Power cord length: 0.64 m
CAUTION! MPM agd S.A. reserves the right to technical changes!
Proper disposal of the product (waste electrical and electronic
equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be
disposed with other type of municipal waste. Used equipment may have a negative impact on the
environment and health of people due to potentially containing hazardous substances, mixtures and
components. Mixing electric waste with other types of waste or disassembling those in an unprofes-
sional manner may cause a release of substances that are hazardous to the environment and health.
Used equipment should be handed-over to a point for collection of electric waste. In order to obtain detailed
information regarding the electric waste collection points, the user should contact the municipal point of elec-
tric waste collection or used equipment processing department.
EN
19