Warning - Genmitsu 710W Installationsanleitung

Warning

1 Please read the instruction manual carefully before use
2. Check that the power cord cannot be pulled within the spindle's range of motion before operation to avoid the spindle
tool touching the power cord
3. The socket must be mated to the spindle plug and the plug must never be modified in any way.
4. Do not expose the spindle to rain or moisture
5 When replacing the spindle, be sure to lock the spindle set screws, otherwise, damage to the spindle and personal
injury may result.
6 The shank of the
7. Allow the spindle to idle to the set speed before the tool touches the engraved material. (Note that vibration or wobbling
may indicate improper tool installation in the spindle)
8. Before removing the workpiece from the table, be sure to turn off the power and wait for the spindle tool to come to
a complete stop
9. Do not touch the spindle immediately after the work is completed, as the high temperature of its operation may burn
your skin
02
tool to be used shall be matched to the collet