mH
Zz
o
C
®
=
ABSENTEE RECORDING AND TIMED PLAYBACK
1. Set the timer to OFF (or similar mode: follow directions
Speakers
Power Cord
Power Cord
MAINTENANCE _ turnoff the POWER switch.
1. REMOVING THE RECEPTACLE
LID
Depress the EJECT
button and remove
the cassette
tape
from
the recepta-
cle.
The
recepta-
cle
lid
can
be
removed by pulling
both lower ends of
the lid toward you.
*
Be sure to use both
hands.
for your particular timer) when connecting the cassette
deck and other components.
. Turn on the Power Switch of the components connected
to the timer and make adjustments. (Refer to the Opera-
tors
Manual
of each
component
and
for CS-F110/
CS-F12 adjust the recording levels for absentee record-
ing and output levels for timed playback.)
. Set the timer to the desired time and set to TIMER (follow
directions for your particular timer). The deck and other
components will be turned off.
. Set the TIMER
START
switch
to REC
for absentee
recording and to PLAY for timed playback. Set to OFF for
all other times.
<r
fa
: O.]
Power Cord
Timer
AC Outlet
2. HEAD CLEANING
With cassette hold-
er at ejected posi-
tion,
clean
the
heads with a cotton
swab.
stick
which
has been dipped in
Akai Cleaning Fluid
(Akai Cleaning
Kit
HC-550P).
Also
clean
the
pinch
wheel, the capstan,
and other parts over
which the tape travels.
* — If Akai Cleaning Fluid is not available, use alcohol. Do not use other chemi-
cal cleaners as the rubber parts will deteriorate.
3. HEAD DEMAGNETIZING
4. REPLACING THE RECEPTACLE LID
To replace the lid
The
steel
pole
pieces which form
part of the record-
ing and
playback
heads
become
slightly
magnetiz-
ed after several re-
cording
and play-
back hours and as
a result, the tape
is partially erased
at
high
frequen-
cies. Therefore, head demagnetizing is recommended peri-
odically.
7
onto
holder,
hook
the upper
part of
the lid and fit the
lower
part of the
lid onto holder.
*
Do
not
insert
a
cassette
tape
with
the receptacle lid off.
*
The receptacle lid is
properly
attached
when it is even with
the front panel.