EN
SAFETY NOTICES
■
Keep the packaging material away from
children and animals. There is a danger of
suffocation.
■
The product is not a toy. Do not leave
young children and animals unsupervised
with the product!
■
Never stare directly into the cone of light!
Also do not use any visual aids to look into
the cone of light! Never point the cone of
light directly at other people or animals!
There is a risk of glare.
■
No liquid must get inside the housing as this
may cause a short circuit. Do not immerse
the product or USB cable in water or
other liquids!
Do not use the product if liquid has got
inside it and have it checked in a specialist
workshop before using it again.
■
The product has a built-in battery. It must
not be thrown into a fire or exposed to
high temperatures of over +50°C. Do not
disassemble the battery! Do not place any
heavy objects on the product. The battery
could ignite.
■
If the battery has leaked, do not allow your
skin, eyes and mucous membranes to come
into contact with the battery acid. If you
touch battery acid, rinse the affected areas
with abundant clear water straight away
and seek medical assistance immediately.
There is a danger of burns from battery
acid.
10
■
Do not stick any metal objects into the
sockets. These might cause bridging of the
contacts. A short circuit between the con-
tacts may cause burns or a fire.
■
If the product falls into water while it is
connected to the mains power, pull the
mains adapter out of the plug socket imme-
diately! Only after this should you retrieve
the product from the water.
■
Keep the product away from combustible
materials and substances.
■
Make sure that the USB cable is not
squashed, bent or laid over sharp edges
and does not come into contact with hot
surfaces.
■
In the event of damage / faults, switch the
product off immediately. Do not use the
product if it is damaged.
■
Do not make any modifications to the
product. The LEDs cannot be replaced. The
product may only be taken apart and / or
repaired by the manufacturer, customer
service department or a similarly qualified
person (e.g. specialist workshop) in order
to avoid any hazards.
■
Protect the product from: impacts, sub-zero
temperatures, temperature fluctuations and
persistent moisture.