Electrical Safety; Safety In The Workplace - Royal Catering Rcct-110/45S-Led Bedienungsanleitung

ATTENTION! Read all safety warnings and all instructions. Failure to follow the
warnings and instructions may result in electric shock, fire, and/or severe injury or
even death.
The terms "device" or "product" are used in the warnings and instructions to refer to the:
LED BAR TABLE.

ELECTRICAL SAFETY

a) The plug must fit the socket. Do not modify the plug in any way. Using original plugs
and matching sockets reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers, and refrigerators.
There is an increased risk of electric shock if the earthed device is exposed to rain,
comes into direct contact with a wet surface or is operating in a damp environment.
Water getting into the device increases the risk of damage to the device and of
electric shock.
c) Use the cable only for its designated use. Never use it to carry the device or to pull
the plug out of a socket. Keep the cable away from heat sources, oil, sharp edges or
moving parts. Damaged or tangled cables increase the risk of electric shock.
d) Do not use the device if the power cord is damaged or shows obvious signs of wear.
A damaged power cord should be replaced by a qualified electrician or the
manufacturer's service centre.
e) To avoid electric shock, do not immerse the cord, plug or device in water or other
liquids. Do not use the device on wet surfaces.
f) Do not use in very humid environments or in the direct vicinity of water tanks.
g) Before the first use, please check whether the main voltage type and current
comply with the indicated data on the type plate.

SAFETY IN THE WORKPLACE

a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may
lead to accidents. Try to think ahead, observe what is going on and use common
sense when working with the device.
b) If you are unsure about whether the product is operating correctly or if you find
damage, please contact the manufacturer's service centre.
c) Only the manufacturer's service centre may make repairs to the product. Do not
attempt to make repairs yourself!
d) Only the manufacturer's service point may repair the device. Do not attempt any
repairs independently!
e) In case of fire, use a powder or carbon dioxide (CO2) fire extinguisher (one intended
for use on live electrical device
f) s) to put it out.
g) Please keep this manual available for future reference. If this device is passed on to
a third party, the manual must be passed on with it.
EN