SOMFY Amy 1 RS100 io Anleitung Seite 9

Amy 1 RS100 io
1] Drill 2 horizontal holes through the indicated drill marks on each side inside
the circular back cover.
2] Fix the circular back cover using screws appropriate for hole size and wall
type, following the orientation indicated inside the circular back cover.
NOTICE
Make sure Amy 1 RS100 io is switched on before clipping the module (refer to
Switching on Amy 1 RS100 io).
3] Clip the Amy 1 RS100 io module onto the circular back cover. Press firmly on
the front of the module, on the right and left near the my button as close as
possible to the translucent circle without pressing on the edges of the module
(to avoid unwanted radio transmission), until it clicks into place.
2.6.Use as a remote control
NOTICE
Amy 1 RS100 io can be used as a remote control without being wall-mounted. However, care must be taken to ensure
that the circular back cover is securely attached to Amy 1 RS100 io module to protect the back access from any risk of
damage and avoid accidental activation.
1] Take the circular back cover and clip the Amy 1 RS100 io module onto it,
following the orientation indicated inside the circular back cover. Press firmly
on the front of the module, on the right and left near the my button as close
as possible to the translucent circle without pressing on the edges of the
module (to avoid unwanted radio transmission), until it clicks into place.
2] Amy 1 RS100 io can therefore be used as a remote control that can be put
down and moved around.
2.7.Tips and advice on installation
2.7.1.Questions about the product?
Observations
The selected motorised product does not react
at all when a button on Amy 1 RS100 io is
pressed (No LED reaction when pressing the
buttons).
The selected motorised product does not react
at all when a button on Amy 1 RS100 io is
pressed (No LED reaction in the front when
pressing a button AND in the back when pressing
the On/Off button).
The selected motorised product does not react
at all when a button on Amy 1 RS100 io is
pressed but the LED lights up.
The selected motorised product does not react
at all when a button on Amy 1 RS100 io is
pressed but the LED lights up and the control
point is paired with this motorised product.
The motorised product does not react when the
indoor temperature rises (the scenes
programmed in TaHoma in the event of a
change in indoor temperature do not launch).
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
Amy 1 RS100 io is switched off, the
front panel buttons (Up, Stop/my,
Down) are deactivated.
The control point battery is low.
The control point is not paired with
this motorised product.
External radio equipment is
interfering with the radio reception.
The temperature feedback to
TaHoma is deactivated on Amy 1
RS100 io.
1]
2]
3]
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy 1
RS100 io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy 1
RS100 io.
Turn off any nearby radio
equipment.
Check sensor status on TaHoma
application and refer to Use with
TaHoma if necessary.
EN
9