Party Light & Sound PARTY-12RGB Bedienungsanleitung Seite 7

ENGLISH
TROUBLE SHOOTING
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem
No sound when power
on
No sound from the mi-
crophone
No sound after inserting
USB/TF card
If Speaker makes loud
noises
SPECIFICATIONS
Input voltage
Built-in battery
Power
FM frequency band
VHF mic frequency
Max. RF transmission power
BT frequency
Max. RF transmission power
Dimensions
Weight
Possible cause
1. No input source
2. Volume down
1. Bad mic connection
2. Mic not switched on
3. Mic volume down
1. Incorrect file format
2. Bad connection of USB/TF card
1. Microphone switched on but may be
too close to the speaker
2. Microphone switched on but is not
being used.
3. Microphone volume may be too loud
4. Mobile phone is being used too close
to the speaker
5. Other wireless equipment may be
placed very close to the speaker.
PARTY-12RGB
15V�� 2A via supplied 100-240V~ mains adaptor
Lithium 11.1V�� 2.2Ah
700W
32.5 x 29.5 x 52cm
6.25kg
©Copyright LOTRONIC 2024
Solution
1. Connect an AUX signal
2. Adjust volume
1. Plug in the mic properly
2. Switch mic on
3. Increase mic volume
1. File format should be MP3
2. Plug in USB/TF card properly
1. Keep the microphone 2 meters away
from the speaker
2. Turn off microphone if not in use.
3. Adjust microphone volume to lower
mode
4. Keep mobile away from the speaker
whilst attending a call.
5. Keep the speaker away from
other wireless equipment
PARTY-15RGB
Lead-acid 12V�� 4.5Ah
87.5MHz - 108MHz
202.2MHz
7.66dBm
2402-2480MHz
3.77dBm
43 x 36 x 60cm
800W
8.75kg
7