Irradio VDP-IR850WHD Benutzerhandbuch Seite 31

Step 2: Select the projected image settings, press OK to enter, select [Auto Trapezoid] in
the [Projection] column, and turn off [Auto Trapezoid] to enter the manual adjustment
mode
Step 3: Select [4-Point Trapezoid] and press OK to enter the page, use the direction
buttons of the remote control or the projector to adjust the projected image according to
the graphics. After adjusting the current point, press the OK button to go to the next
corner point.
Step 4: After adjusting the four points, press the return key to save the current state
INPUT SOURCE
A. HDMI mode
Step 1: Connect the projector and equipment with HDMI cable.
Step 2: Press and hold the source button >> of the projector or remote control to enter the
input source interface or use the button to select HDMI on the main interface of the
projector.