Irradio VDP-IR850WHD Benutzerhandbuch Seite 22

VDP-IR850WHD
INTRODUCTORY NOTE
Irradio thanks you for purchasing this projector and for the trust you have placed in our
brand. We are confident that we will be able to fully meet your every need thanks to our
constant commitment to the search for innovative and environmentally friendly
technological solutions.
Please read this manual in its entirety before installing and using the projector: it contains
important information which may prove essential for the utmost exploitation of its features,
as well as for its safe use, and should be kept for future reference.
Irradio technical service is at your disposal for any questions, suggestions or clarifications.
IMPORTANT SAFETY INFORMATION:
•
Check projector conditions before proceeding with its installation: if anomalies or
damage are found, do not in any way switch it on and contact the retailer from whom
it was purchased.
•
The projector is intended for use inside in residential, commercial and service
environments and in any case indoors: its safety is be guaranteed if it is used in
environments exposed to the weather.
•
Before proceeding with installation, make sure that the mains voltage corresponds to
the value permitted by the projector, i.e. 220-230 V AC 50 Hz.
•
The projector can be installed either on a flat surface or on the ceiling. In the latter
case it is necessary to use brackets and/or supports, which must absolutely be installed
by specialised personnel in compliance with the criteria of the rule of art: sloppy,
inaccurate or badly executed installation may cause falling and consequent damage to
the device, with the possibility of even serious injury and trauma to persons or animals.
•
In the case of installation on a flat surface, check that there are no obstacles in the
vicinity that make operation uncomfortable or unsafe.
•
In case of prolonged inactivity, disconnect the projector from the mains and remove
the batteries from the remote control.
•
The projector is not a toy and may be dangerous for children even after it has been
decommissioned, as some parts may be swallowed if disassembled or cause injury.
•
Avoid setting up or using the projector in excessively hot, excessively cold, excessively
dusty or humid places, in atmospheres saturated with substances, gas or smoke and in
direct sunlight, even if there is glass in between.
English