VTech VM4254 Schnellstartanleitung Seite 6

1
Connect the baby monitor
The parent unit turns on automatically after connecting the power adaptor to the power sock-
et and the battery LED light illuminates.
NOTE NOTES
• The rechargeable battery in the parent unit is built-in.
• Use only the power adaptors supplied with this product.
• Make sure the parent unit and the baby unit are not connected to an electronically/timer controlled electric
outlet.
• Connect the power adaptors in a vertical or floor mount position only. The adaptor prongs are not
designed to hold the weight of the parent unit and the baby unit, so do not connect them to any ceiling,
under-the-table, or cabinet outlets. Otherwise, the adaptors may not properly connect to the outlets.
• Make sure the parent unit, the baby unit and the power adaptor cords are out of reach of children.
Charge the parent unit battery
When you have connected and turned on the parent unit, the battery will be charged
automatically.
Notes
NOTE NOTES
• Before using the baby monitor for the first time, charge the parent unit battery for 12 hours. When
the parent unit battery is fully charged, the battery icon segments are solid
• It takes longer to charge the battery when the parent unit is turned on. To shorten the charging time,
turn the parent unit off while charging.
• The standby time varies depending on the sensitivity level set, your actual use and the age of the
battery.
The battery icon indicates the battery status (see the following table).
Battery indicators
The screen displays
The light flashes.
The battery icon segments
are solid .
Battery status
The battery has very little
.
charge and may be
only a short time.
The battery is fully charged.
Action
Charge without interruption (about
used for 30 minutes).
To keep the battery charged,
connect it to AC power when in use.
6
.