Common Problems Possible Causes Treatment - Atomstack A5 Pro Bedienungsanleitung

Shenzhen AtomStack Technologies Co., Ltd.

6. Common Problems Possible Causes Treatment

Common
problem
The engraving
machine
cannot be
connected to
the software
(here refers to
the
LaserGRBL
software)
The engraving
line is not
straight
Possible cause
Driver Missing,
Cannot connect
Multiple LaserGRBL
software open repeatedly
Incorrect port number
Incorrect baud rate
selection
the data line is
unconnected
USB port problem of the
computer
The belt is not tight
Belt screws are not locked
at both ends
Rollers are not locked,
brackets are wobbling
The laser stand extends
too much that causes the
laser to shake.
support@atomstack3d.com
Solution
In the LaserGRBL software,
click "Tools">"install
CH340 Driver" to install the
driver, and restart the
computer after installation to
connect
Close LaserGRBL software
that is open repeatedly
Select the correct port
number
Baud rate to be selected:
115200
Check whether the data line
is connected correctly.
Try a different USB port
Re-tension the belt
Tighten the set screws on
both ends of the belt
Adjust the eccentric nut
under the bracket, lock the
eccentric nut so that the
bracket does not wobble.
Raise the laser to let it as
close to the top as possible
to reduce laser wobble
29