ATOMSTACK A5 Pro Bedienungsanleitung Seite 13

Shenzhen AtomStack Technologies Co., Ltd.
b. Engraving mode usually choose "line to line tracking" and "1bit
dithering", 1bit dithering is more suitable for engraving grayscale graphics.
If you are going to cut, select the vector graphics or centerline engraving
mode.
c. Engraving quality essentially refers to the line width of the laser
scan, this parameter mainly depends on the size of the laser spot of the
engraving machine, AtomStack A5 PRO engraver uses rectangular spot for
0.23*0.23mm, the core energy area of the spot size is about 0.08*0.15mm,
Therefore, it is recommended to use an engraving quality of 8, The
response to laser illumination varies from different materials, so the exact
value depends on the specific engraving material.
d. at the bottom of the preview window, the image can also be rotated,
mirror, cut, etc. operations.
e. After completing the above settings, click next to the the settings of
carving speed, carving energy and carving size.
C. Engraving speed, engraving energy and engraving size Setting
Picture 3.9 Introduction of Setup Interface
support@atomstack3d.com
13