Positioning - Atomstack A5 Pro Bedienungsanleitung

Shenzhen AtomStack Technologies Co., Ltd.
D. Take out the fixed focus piece and finish focusing.

7. Positioning

A. The engraver does not know what position to carve, so there is one
important task before you start carving, that is positioning. We will
complete the positioning operation in three steps.
B. Select the "Move to Center" button, the laser will move to the center
of the pattern, placed the engraving below the laser at that time.
Picture 3.14 Take out the fixed focus piece
support@atomstack3d.com
2mm
17