Werbung
EN
• Do not face the camera towards any objects with bright lights, including
sunshine, bright lamp lights, etc.
• Do not place the camera near any outlets, including the air conditioner
vents, humidififier
• Do not install the camera
• Do not face
• Keep the camera
WiFi routers and phones in order to avoid wireless interference.
The device prompts ofine?
l. Check whether the equipment is in the power-on state, and observe
whether
the working light of the equipment
2. Confirm that the current location
is stable, make sure that the wifi signal is above 85%. You can try to use
the third-party
signal coverage and interference status. If the coverage is poor and the
interference
position or adjust the router position or use a second-stage
3. If the device is located
to obtain
closer place or ensure the Wi-Fi signal strength
improve
the Wi-Fi performance
4. Delete the camera
resetting the device. Check whether the device firmware and application
program
5. Avoid using wifi extenders.
Update router or Wi-Fi password?
Delete the camera
use the new Wi-Fi and password
07 / ImportantNoteson
Reducing
outlets, the heat transfer
in places with strong wind.
the
camera
towards
at least I meter away from any wireless devices, including
wifi analysis tool "wifi analyzer" to analyze the current wifi
is large, it is recommended
far away from the router, which results in the inability
a good Wi-Fi signal, it is recommended
from your ieGeek Cam account
are the latest version.
from your ieGeek Cam account.
False Alarms
vents of projectors,
a mirror.
08 / FAQs
is on normally.
has good wifi coverage
to replace the camera
of the home.
to add it again.
etc.
and the network
installation
router.
to move the router to a
is to be over than 85% to
and add it again after
After resetting
the device,
Werbung
