Werbung
To Adjust
EN
When tilling in a confined area or between rows, the
cultivator may be used with only the inner blades installed.
Wear gloves and remove the two hitch pins to remove the
two outer blades (Fig. M), and then insert the hitch pins into
the locking hole-2 (Fig. N & O).
Fig. N parts description see below:
N-1
Locking Hole-1
N-2
Locking Hole-2
NOTICE:
Do not force the blades on or off the drive shaft.
If you experience difficulty when removing the blades,
apply some penetrating oil on the shaft. When reinstalling
the blades, make sure to clean and oil the drive shaft and
the blades.
CLEAN THE UNIT
Parts of plants, such as roots, can become tightly
wrapped around or between the rotating blades during
operating. To clean the rotating blades:
◾
Remove the battery.
◾
Wear gloves. Clean the pieces of roots, clogged soils
or plants on the blade, guard or the gear box. For
thorough cleaning, remove the blades and guard to
wash them thoroughly. For detailed replacement steps
please see above section
"REPLACING OR ADJUSTING THE BLADES".
◾
Wipe the tool surface with a clean cloth moistened with
a mild soap solution
STORING THE UNIT
◾
Remove the battery pack from the tool.
◾
Remove the cultivator attachment from the power head
and cover the attachment shaft with end cap to avoid
dirt getting into the coupling.
◾
Store the tool in a dry, well-ventilated area, out of the
reach of children. Do not store the unit on or adjacent
to fertilizers, gasoline, or other chemicals.
12
CULTIVATOR ATTACHMENT — CTA9500
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric machines must be
returned to an environmentally compatible
recycling facility.
Werbung
