TecTake 405359 Bedienunsanleitung Seite 19

5. Installation
Uninstalling the ISOFIX system
1.To free the Top Tether, press the button and pull the tether strap in the opposite
direction(the indicator will change from green to red color), in order to take off
the top tether.
2.To free the lSOFIX anchoring, press backwards the ISOFIX System unlock buttons
(the indicator will change from green to red color), in order to free the seat from
the vehicle ISOFIX anchoring system.
5.3 100-150cm Install Forward Facing
5.3.1 Ensure that the child seat's 5-point harness and buckle is removed
correctly(see 4.4)
5.3.2 Ensure the seat is ready to install in forward facing (Group 2/3), pull the
backrest reclining handle to adjust to angle to any position 1 or 2, then release the
handle.
5.3.3 It is necessary swivel the seat 180º to place the seat in the direction of travel.
Release the backrest rotating handle when the seat is in the desired position.
5.3.4 Before installing the safety seat, place your child in the seat and adjust the
headrest to the correct height(see 4.9).
5.3.5 Place the child safety seat in the back seat of the vehicle facing in the directi-
on of travel
5.3.6 Hold the child seat with both hands and insert the two ISOFIX arms firmly
into the vehicle's ISOFIX anchoring points until they fasten with a click on both
sides. The red button will change to green on both sides .
5.3.7 Shake the seat to check that it is correctly anchored to the vehicle's ISOFIX
points.
5.3.8 Place your child in the safety seat.
5.3.9 Pass the vehicle seat belt through the bottom of the armrest, ensure the lap
belt is stretched as low as possible over the child's hips, buckle the vehicle seat
belt until hear a click. Place the diagonal belt through red belt guide hook and
must pass the middle between child's shoulder and neck.
5.3.10 The insertion guides facilitate the installation of the safety seat with the aid
of the ISOFIX securing points and prevents damage to the upholstery. When not in
use they should be removed and stored in a safe place. In vehicles with a reclining
back the insertion guides should be removed before the seat is reclined. Problems
that may arise are generally the result of accumulation of dirt or foreign bodies in
the insertion guides and the clasps. To solve this type of problem simply clean the
part in question.
- 19 -