Ronix RP-4100 Bedienungsanleitung Seite 29

PRESSURE WASHER
ATTENTION
Impurities in the water can damage the high-pressure pump and the
accessories.
Water supply from mains
Drawing in water from the open reservoirs
This high-pressure cleaner is suited to work with the YILI suction hose with
backflow vale to draw in surface water, e.g. from water butts or ponds.
Fill the suction hose with water.
Screw the suction hose into the water connection of the appliance and
insert it into the water source (e.g. rainwater drum).
Bleed the device as follows prior to operation:
- Turn on the appliance power switch.
- Unlock the lever of the trigger gun.
- Push the lever of the trigger gun, the device will switch on.
- Let the device run (max. 2 minutes) until the water exits the trigger gun
without bubbles.
- Release the lever of the trigger gun.
- Lock the lever of the trigger gun.
OPERATION
ATTENTION
Dry running of more than 2 minutes leads to damage of the high-pressure
pump. If the appliance does not build up pressure within 2 minutes,
switch the appliance off and proceed in accordance with the instructions
in Chapter "Troubleshooting"
HIGH PRESSURE WASHER OPERATION
Keep a distance of at least 30 cm when using the jet for clean-
ing painted surfaces to avoid damage.
|
2 7
User Manual