Tomahawk COACH BY COLOR COMPUTER Bedienungsanleitung Seite 40

WHEN I CARRY OUT THE OFFSET MEASUREMENT, THE FOLLOWING SCREEN APPEARS.
Version 1.0 Coach By Color Computer | Copyright by Indoorcycling Group GmbH 2014 | www.indoorcycling. com
FAQ
The cause of this is not clear. Either the OFFSET measurement has not
been carried out properly, or a mechanical error is at fault.
Please check the following:
• Carry out the measurement again (a minimum of 3 times).
If the measurement is successful, the displayed value should
not fluctuate by more than ± 3 digits.
• Please adhere carefully to the instructions on how to carry
out the Offset measurement. The measurement
will definitely fail if you do not let the pedals run down as
soon as the STOP symbol appears.
• During the OFFSET measurement, you may not use the brake.
• At the primary drive, it is imperative that both foot pedals
are attached.
• Inspect the belt tension.
Please go to the SETUP > SYSTEM CHECK menu and note down the
displayed error codes (ERROR #).
Then contact servicing and provide them with the displayed error
codes (ERROR #).