Settings - Brake Calibration - Tomahawk COACH BY COLOR COMPUTER Bedienungsanleitung

– BRAKE CALIBRATION
It is necessary to calibrate if:
• The level display of the resistance does not reach 0% or 100% at the end positions.
• An exclamation mark (!) is shown instead of the level as a % on the display.
SELECTING BRAKE
CALIBRATION MENU
ITEM
If the values lie outside a certain range, the calibration fails and a red screen appears. Reattempt
the calibration and make sure you follow the instructions carefully. If the calibration fails again,
the resistance system must be adjusted mechanically. Please refer to technical service in this
case.
CALIBRATION
FAILED
SETTINGS
TURN THE RESISTANCE
DIAL ALL THE WAY TO
THE LEFT (MINIMIUM
POSITION)
ERROR, PLEASE
CALIBRATE
TURN THE RESISTANCE
DIAL ALL THE WAY TO
THE RIGHT (MAXIMUM
POSITION)
CALIBRATION
SUCCESSFUL
13