Connecting The Loudspeakers / Bi-Wiring Operation - Audio Physic AVANTERA Bedienungsanleitung

Connecting the Loudspeakers
1. Please switch off all equipment in your Hifi system before you begin
to connect your loudspeakers.
2. Attach the loudspeaker cable to the connectors on the loudspeakers.
When doing so, please make sure that you have the right polarity. As a
rule, loudspeaker cables are accordingly labelled, either by a permanent
marking on one of the two conductors of the cable by "+" and "-"
markings on the cable ends.
3. Now connect the cable to your amplifier and make sure that you have
the right polarity here.
4. The AVANTERA`s connectors, which are shown in the image on the right,
accept both spades and banana plugs. Loose cable strands oxidise easily
and are not suitable for a permanently high-quality listening experience.
"Bi Wiring" Operation
If your AVANTERA is fitted with a bi-wiring terminal and you would like to use this option, please
connect the loudspeaker cable from the amplifier for the left loudspeaker to the upper two
connectors on the left loudspeaker in order to control its midrange area and tweeter system and
a further cable to the connectors underneath in order to control the woofer system. Carry out the
same steps on the loudspeaker to the right of the listening position. Please remove and retain the
respective bi-wire bridges on the loudspeaker terminals before connecting the cables.
16
Super Seven: The body of the AVANTERA
tilts backwards at an angle of 7° in order to
optimise time-correct rendition.
Heavy Metal: The Hyper Holographic
AVANTERA drivers are flush with the
front baffle made of metal designed to
reduce resonances.