Connecting The Loudspeakers / Bi-Wiring Operation - Audio Physic VIRGO III Bedienungsanleitung

Connecting the Loudspeakers
1. Please switch off all equipment in your Hifi system before you begin to connect your AUDIO PHYSIC loudspeakers.
2. Attach the loudspeaker cable to the connectors on the loudspeakers. When doing so, please make sure that
you have the right polarity. As a rule, loudspeaker cables are accordingly labelled, either by a permanent
marking on one of the two conductors of the cable by "+" and "-" markings on the cable ends.
3. Now connect the cable to your amplifier and make sure that you have the right polarity here.
4. The VIRGO`s connectors, which are shown in the image on the right,
accept both spades and banana plugs. Loose cable strands oxidise easily
and are not suitable for a permanently high-quality listening experience.
"Bi Wiring" Operation
If your VIRGO III is fitted with a bi-wiring terminal and you would like to use this option, please connect the
loudspeaker cable from the amplifier for the left loudspeaker to the upper two connectors on the left loudspeaker in
order to control its midrange area and tweeter system and a further cable to the connectors underneath in order to
control the woofer system. Carry out the same steps on the loudspeaker to the right of the listening position. Please
remove and retain the respective bi-wire bridges on the loudspeaker terminals before connecting the cables.
16
Super Seven: The body of the VIRGO III tilts
backwards at an angle of 7° in order to optimise
time-correction rendition.
The insight view shows the clever design and the
isolated chambers for midrange and tweeter.