Unpacking And Assembly - Audio Physic AVANTERA Bedienungsanleitung

Unpacking and Assembly

1. Place the boxes on the floor, making sure that the product labels are facing up. Carefully
open the packaging on the long side where it has been taped up, as shown in the illustrations
below (illustration similar), preferably using a pocket knife or kitchen knife.
2. Remove the accessory packs from the boxes.
3. Carefully remove the loudspeakers, together with their protective foam pads, from the
upright box. It is ideal if two people carry out this step. Make sure that you do not touch the
drivers when removing and handling the loudspeakers as this may cause irreparable damage
to the drivers.
4. Now remove the foam cover from the top and carefully pull down the foil, so that you can
easily attach the foot construction.
5. Remove the metal stands from the accessory pack and screw the spikes into the designated
inserts.
6. Tighten the lock nuts onto the spikes from above.
7. Now lay the metal stands with the attached spikes on the loudspeaker and adjust the stands
so that their screw inserts are aligned with the inserts in the loudspeaker base.
14
Correct: In order to correctly
unpack the loudspeaker, the top of
the loudspeaker should be facing
down. This means that you will
easily be able to hold on to the
bottom of the loudspeakers when
carefully pulling them out of
the box and also enables you to
attach the foot construction
without difficulty.
False: If the top of the
loudspeaker is facing up,
you will have to turn the
loudspeaker upside down
once you have removed it
from the box in order to
attach the foot
construction.