Unpacking And Assembly - Audio Physic VIRGO III Bedienungsanleitung

Unpacking and Assembly

1. Place the boxes on the floor, making sure that the product labels are facing up. Carefully open the packaging
on the long side where it has been taped up, as shown in the illustrations below (illustration similar), preferably
using a pocket knife or kitchen knife.
2. Remove the accessory packs from the boxes.
3. Carefully remove the loudspeakers, together with their protective foam pads, from the upright box. It is ideal
if two people carry out this step. Make sure that you do not touch the drivers when removing and handling
the loudspeakers as this may cause irreparable damage to the drivers.
4. Now remove the foam cover from the top and carefully pull down the foil, so that you can easily attach the
foot construction.
5. Remove the metal stands from the accessory pack and screw the spikes into the designated inserts.
6. Tighten the lock nuts onto the spikes from above.
7. Now lay the metal stands with the attached spikes on the loudspeaker and adjust the stands so that their
screw inserts are aligned with the inserts in the loudspeaker base.
14
Correct: In order to correctly
unpack the loudspeaker, the top
of the loudspeaker should be
facing down. This means that you
will easily be able to hold on to
the bottom of the loudspeakers
when carefully pulling them out
of the box and also enables you
to attach the foot construction
without difficulty.
False: If the top of the
loudspeaker is facing up,
you will have to turn the
loudspeaker upside down
once you have removed
it from the box in order
to attach the foot
construction.