Royal Catering RCS-230D Bedienungsanleitung Seite 11

Fault
The appliance is unusually loud
Electrical Wiring
Appliances are supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13-Amp fuse as
standard. The plug is to be
connected to a suitable mains socket. Appliances are wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue)to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
All appliances must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Disposal
EU regulations require refrigeration product to be disposed of by specialist companies who remove
or recycle all gasses, metal and plastic components. Consult your local waste collection authority
regarding disposal of your appliance. Local authorities are not obliged to dispose of commercial
refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally.
Compliance
All parts have undergone strict product testing in order to comply with regulatory standards and
specifications set by international, independent, and federal authorities.
This products has been approved to carry the following symbol:
The R600a and R290 refrigerant used by this refrigerator.
WARNING:
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process, other than those
recommended by the manufacturer. Do not damage the refrigerant circuit. Do not use electrical
appliances inside the food storage compartments of the appliance.
EN
Possible cause
The waler container is
damaged
The drip tray is overflowing
Loose nut / screw
The appliance has not been
installed in a level
Action
Call your agent or qualified
Technician
Empty the drip tray (if
applicable)
Check and tighten all nuts and
screws
Check installation position and
change if or stable position
necessary