Safety Instructions; General Information - Atlas Copco Ltd 28 R8-Re Produktanweisungen

LTD28 R-RE EN Safety and operating instructions
Safety and operating instructions

Safety instructions

Warning
Make sure you are familiar with the operating instructions before you use the machine.
The machine, together with any attachments and accessories, must never be used for anything other than
the designated purpose.
All locally legislated safety rules with regard to installation, operation and maintenance shall be respected
at all times.
The machine shall be fixed with a bracket or, if hand held, only used together with a torque reaction bar
(optional).
Refer installation and servicing to qualified personnel only.
Before making any adjustments (e.g. changing sockets) disconnect the machine from the compressed air
line.
Never use the nutrunner without making sure that the clutch releases. Be aware of fluctuations in air pres-
sure.
Check the direction of the rotation before using the machine.
Operators of nutrunners with a torque reaction bar should take particular care to avoid injuries due to
squeezing. For safety reasons – never allow anyone to operate the machine unless he is trained and thor-
oughly familiar with how the machine works in different circumstances. Refer to the section headed "Reac-
tion bar".
Never put your hand on or close to the reaction bar while the machine is being used.
Check that the power socket is properly fastened. Replace the retaining or locking pin when necessary.
Also replace any worn socket.
Keep hands, long hair or other objects away from the rotating socket.
When using a suspension yoke, check that it is in good condition and correctly fastened.

General information

EC DECLARATION OF INCORPORATION
We Atlas Copco Industrial Technique AB, S-105 23 STOCKHOLM, SWEDEN declare that this product
(with name, type and serial number, see front page) fulfils the following essential requirements of Machin-
ery Directive 2006/42/EC, and must not be put into service until the final machinery, into which it is to be
incorporated, has been declared in conformity with that Directive.It is also in conformity with the following
Directive(s):
2006/42/EC
Harmonised standards applied:
ISO 11148-6
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique, Stockholm, Sweden
Stockholm, 1 July 2013
Tobias Hahn, Managing Director
Signature of issuer
RoHS and WEEE
Information concerning Restriction of Hazardous Substances (RoHS):
This product and its information, meets the requirements of the RoHS Directive (2011/65/EU).
© Atlas Copco Industrial Technique AB - 9836 9411 06 3