Raddy DT7 Bedienungsanleitung Seite 11

 After selecting your city name, press the "CITY" button again to confirm the setting and return to the normal mode.
 If your city name is not in the table, you can press and hold the "CITY" button for more than 2 seconds in standard
mode to enter the city name custom setting mode.
 Before entering this setting, you need to check the time zone, longitude and latitude of your city.
 After entering this setting mode, the set items will starts to flash, press the "
characters you need.
 Press the "CITY" button to confirm the item has been set and go to the next one, the sequence of setting items is as
follows:
The first character of the city name
 The characters that can be selected when setting a city name: letters "A~Z", spaces and "-"
 The time zone setting range: GMT -11:00~GMT+14:00
 Latitude setting range: 0-65 ° N and 1-64 ° S, where "N" represents north latitude and "S" represents south latitude.
 Longitude setting range: 1-179 ° W and 0-180 ° E, where W represents west longitude and E represents east
longitude.
 If there is no valid operation within 20 seconds, it will automatically return to normal time mode from the city set
mode.
Temperature & Humidity detection
 Indoor temperature measuring range: -9.9°C (+14°F) ~ +50°C (+122°F), LL.L °C(°F) will be displayed if value lower
than -9.9°C (+14°F), HH.H °C(°F) will be displayed if value higher than +50°C (+122°F).
 Outdoor temperature measuring range: -40°C (-40°F) ~ +70°C (+158°F), LL.L °C(°F) will be displayed if value lower
than -40°C (-40°F), HH.H °C(°F) will be displayed if value higher than +70°C (+158°F).
 Indoor and outdoor humidity measuring range: 20%RH ~ 95%RH, 19%RH will be displayed if value lower than
20%RH, 96%RH will be displayed if value higher than 95%RH.
RF transmission procedure
 The weather station automatically starts receiving transmission from remote sensor for outdoor temperature &
humidity after batteries inserted.
 The remote sensor will automatically transmit temperature and humidity data to the main unit after batteries inserted.
 If the weather station failed to receive transmission from remote sensor ("- -.-"and "--" display on the LCD), Press
and hold the 【CH】 button for 2 seconds, RF icon
the channel.
 The weather station receive remote signals of up to 3 channels, press 【CH】 button to switch and display data of
different channels, when the symbol
every 5 seconds.
Trend display
When the pressure/temperature/humidity is rising, the arrow will point upwards.
When the pressure/temperature/humidity is falling, the arrow will point downwards.
When the pressure/temperature/humidity is steadying, the arrow will point flat.
Query maximum/minimum numerical value
 When the temperature and humidity are shown in the LCD, The weather station began to record temperature and
humidity maximum and minimum numerical value.
 Press the "
" button, the LCD will display maximum value of temperature and humidity, Press the "
again while the maximum values are displayed to show the minimum temperature and humidity.
 The temperature and humidity maximum/minimum value will will be recorded again after pressing and hold "
button for 2 seconds.

The memory value of the day will be automatically cleared at 0:00 every night.
DT7 Manuals
 
Second character
will be flashing，the main unit will rescan the launch signal of
appears, the data of different channels will be displayed automatically
11
 Time zone  Latitude  Longitude
Third character
" buttons to select the
" or "
" button
"