Making A Phone Call; Useful Functions; Restoring To The Factory Settings - Panasonic RP-BTD10 Bedienungsanleitung

Making a phone call

With Bluetooth enabled phones (cell phones or smartphones) that support the
®
"HSP" or "HFP" Bluetooth profile, you can use the unit for phone calls.
®
• HSP (Headset Profile):
This profile can be used to receive monaural sounds and establish two-way
communication using the microphone on the unit.
• HFP (Hands-Free Profile):
In addition to the HSP functions, this profile has the incoming and outgoing calls
function.
1
Connect the Bluetooth ® enabled phone and unit (→ P. 3)
2
When answering an incoming call
Press Call on the unit
and answer the call
• During an incoming call,
ringtone will sound from the
speaker and the LED will blink.
• (HFP only) To reject the
incoming call, press and hold
Call until the ringtone stops.
Left
Call
Microphone
3
Start talking
• The LED will repeatedly blink 2 times during a call.
• The volume can be adjusted during a phone call. For setting instructions, see
page 4.
4
Press Call to end the phone call
• A beep will sound.
When making an outgoing call
Make an outgoing call on
the Bluetooth ® enabled
phone
• Also refer to the operating
manual for the Bluetooth
®
enabled phone.
(Checking and operation steps on the
unit are explained below)
• During an outgoing call, ringtone
will sound from the speaker and
the LED will blink.
• To cancel the outgoing call,
press Call .
A beep will sound.
• (HFP only) When the phone is
idle, press and hold Call for
approximately 2 seconds. An
outgoing call will be made to the
last dialed number. One short
click will sound from the speaker
and the LED will blink.
■
Note
• There may be instances when hands free setting needs to be done on the
Bluetooth ® enabled phone.
• Depending on the Bluetooth ® enabled phone, you may hear incoming and
outgoing call ringtones of the phone from the unit.
• (HFP only) Press and hold the Call
The calling device will be switched between the Bluetooth
the unit.

Useful functions

Resetting the unit
This unit can be reset when all operations are rejected. Connect the unit to a
computer using the USB charging cord. Then press the RESET hole with a thin,
pointed object. Check that the LED (red) goes out. Keep pressing the RESET hole
(→ P. 2) for approximately 5 seconds to reset the unit. All the previous operations
will be cancelled. (The pairing device information will not be deleted.)
Auto power off
If the unit is silent for approximately 5 minutes and operations for Bluetooth
devices are idle during that period, a beep will sound and the power will be
automatically turned off.
LED indicator light
When the battery level is low during use of the unit, the blue blinking LED on the
left speaker will change to red. A beep will sound every 1 minute. When the battery
runs out, the power will turn off.

Restoring to the factory settings

When you want to delete all pairing device information, etc., you can restore the
unit to the factory settings (original settings upon purchase).
1 Turn off the unit
2 Press and hold the power button and Previous
more simultaneously
• The LED on the left speaker will light in red for approximately 2 seconds. The
unit will restore to the factory settings.
on the unit for approximately 2 seconds.
® enabled phone and
®
for 5 seconds or
5
5