Werbung
8
Connections
Connect the transmitter to the sound
source.
The cable can be connected directly to a stereo
mini jack or to a large stereo headphone jack if
the included plug adaptor is used.
Portable CD player, headphone stereo, radio/
tape players, personal computer, etc.
OR
Use the included mini jack/pin cord adaptor to
connect the transmitter to your equipment's
stereo pin terminals.
Amplifi er, TV set, video deck, cassette deck,
DVD player, personal computer, etc.
Connect
the
household AC
supplied AC power adaptor.
Disconnect the AC adaptor from the household
mains socket if the unit is not going to be used for
a long time.
The unit is in the standby condition when the AC
adaptor is connected. The primary circuit is always
"live" as long as the AC adaptor is connected to an
electrical outlet.
Note
The OPR/CHG indicator lights in red when the transmitter
receives input. It does not light just by connecting the
transmitter to an AC power source.
Installation
This unit uses radio waves.
The waves can be transmitted to a range of up to
100 meters.
Note
Under optimum conditions, the headphones can pick
up clean signals from the transmitter to a maximum of
100 meters. Metal between the two units and the pre-
sence of other radio waves can cause interference
to occur at a shorter distance. This interference can
be cleared by moving closer to the transmitter, removing
the obstructions, or changing the transmission frequency
(
see page 12).
You may occasionally experience interference due to
dead spots in the area covered by the transmitter. This
phenomena occurs with any kind of radio signal and is
not a malfunction. Dead spots can be moved by moving
the transmitter and the headphones.
transmitter
to
outlet
using
the
a
Werbung
Kapitel
