cecotec BIGDRY 2000 ESSENTIAL Bedienungsanleitung Seite 30

ENGLISH
Draining the water. Fig. 3
- The water tank inside the device has a maximum capacity of 700 ml and an operating
capacity of 300 ml/day.
- When the water tank is full, the power indicator (2) will light up yellow, and the unit will
automatically switch off. Fig. 4
1. Unplug the device power cord.
2. If the water tank is full, be careful not to spill water. Pull it out, slide the tank lid to
remove it, and drain the water.
3. Refit the tank. Then, press the power button (1) to turn the device on.
Recommendations for use
- For best results, it is recommended to use the dehumidifier in environments with an
humidity above 60%. The most suitable humidity level is 45 to 60%.
- When the temperature is below 5°C, it is recommended to stop operation and let the device
rest for 1 hour every 3 hours to avoid frost. Once the frost has disappeared, switch the
device back on.
4. CLEANING AND MAINTENANCE
- Make sure that the device is switched off and that the power cord is unplugged from the
power outlet.
- Use a cloth to wipe dirt and dust from the surface of the device and the air inlets and
outlets.
- Pull out the water tank to remove it and use a soft cloth to wipe dirt and dust from the
surface of the tank.
- Empty the water tank after each use and every time the power indicator lights up yellow.
5. TROUBLESHOOTING
Problem
The device does not
work.
Low performance
(water is absorbed
less than usual).
30
BIGDRY 2000 ESSENTIAL
Possible causes
The device is not connected to the power outlet.
The power outlet and fuses are in bad conditions.
The water tank is full.
The room door is open.
The air inlet or outlet of the product is being blocked by an object.
There is another appliance generating steam in the room.
Room temperature is too low.