Touch Pen; Battery Installation - Panasonic TY-TPEN6 Bedienungsanleitung

Touch Pen

This product is intended for use only with a touch panel.
Warnings
•
Never attempt to disassemble or modify this product.
To avoid fire, shock, or failure.
•
Be careful not to grasp the infrared-ray-emitting area of the touch pen while using it. This may result in
incorrect operation.
•
Do not press the pen tip down with excessive force.
•
The pen may not work correctly if there is an intense light source or equipment employing infrared rays
nearby. Keep as far away from such light sources as possible.
•
Do not operate the touch pen simultaneously with the remote control for a TV or VCR. Incorrect operation
may result if operated simultaneously.
•
If the touch pen surface becomes soiled, gently wipe off the soiling with a soft cloth.
If the surface becomes extremely soiled, soak a cloth in neutral detergent diluted with water, wring out the cloth
well, wipe off the surface with the cloth, and then finish by wiping with a dry cloth. Be careful not to let water drops
get inside the equipment, as this may cause it to malfunction.
•
If the touch pen will not be used for a long time, remove the batteries to conserve their energy.
Accessories
Pen tip (3)

Battery installation

■ How to install Batteries
Remove the
1
battery cap.
Rotate the cap
counter-clock-wise
to remove.
Precautions on battery use
Incorrect installation can cause battery leakage and
corrosion that will damage the touch pen.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always
use new batteries when replacing the old pair.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon"
with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
6
battery (2)
Insert Refit the
3
2
battery cap.
batteries.
Be sure to insert Rotate the cap
clockwise to
with the correct
refit.
orientation.
Touch pen tip replacement method
If the pen tip becomes worn or
damaged, replace with the
replacement tip included.
Naming / Use
Turn on the selection switch at the rear of the touch
panel.
Infrared-ray-emitting area
Function switch
Press this to use the funcions that
can be set in "Touch Panel Setting
Program" menu.
(Please refer to the operating
instructions of touch panel)
Pen tip
Pressing the pen tip performs the
same operation as clicking the
left button of the PC mouse.
Pull out the old pen tip and
replace with a new one.
Battery cap