Changing Operating Modes - Num'axes Iki Pulse Gebrauchsanleitung

014 `
© Changing operating modes
In the factory, the collar's mode is set to mode 2 [beep sounds + short stimulation for sensitive dog).
To change the collar's mode, when switching on the collar you need to approach and keep the magnetic
key in contact with the orange mark.
A series of beep sounds is emitted [from 1 to 7 beeps) indicating the selected mode.
Keep the magnetic key in contact with the orange mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously
selected,
The chart below indicates how your collar operates according to the mode you have selected :
Number of beep
sounds heard when Operation
switching modes
Beep sounds only
Beep sound + short stimulation
Sensitive dog | Beep sound + long stimulation
Beep sound + progressive stimulation
{short then long) `
Beep sound + short stimulation
Difficult dog Lee sound + long stimulation
Beep sound + progressive stimulation
{short then long)
® Setting the barking detection sen: ty
Your dog's barking is detected by the contact points which sense the vibrations of his vocal cords.
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection. The detection must
therefore be sufficiently sensitive but not overly sensitive. In the factory, detection sensitivity is set on
the medium position (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the protection located at the back of the collar (See. Diagram 3).
- Carefully turn the setting screw according to the sensitivity you wish using the supplied small plastic
screwdriver (See. Diagram 3).