Nitho HEXAGON Kurzanleitung Seite 7

RECONNECTION
M1 & M2 SETUP
To setup M1 or M2 back buttons :
Press & Hold M1 or M2 + Options for few seconds untill the
LEDs starts fast blinking.
Press M1 or M2 to select which back button to assign.
Press any of the default buttons to assign the function to M1
or M2.
Press the " N" button to confirm the selection.
M1 & M2 CLEAR SETUP
To clear the setup of M1 or M2 back buttons :
Press & Hold M1 or M2 for few seconds untill the LEDs starts
blinking.
Press M1 or M2 the LED will start to fast blink.
Press again M1 or M2 to clear the program assigned.