Ransomes TRIPLE 18 Bedienungsanleitung Seite 50

GB-F-NL-48
Fig.15
Fig.16
Fig.17
L - REAR WHEEL STEERING CONTROL (Fig.15)
The rear wheel should be adjusted so that it is straight
(parallel to frame) when the buckhorn is in the straight
ahead position.
To adjust:
1. Place the buckhorn handle in the straight
ahead position.
2. Loosen the locking nuts on the cable ends
directly above the steering tire.
3. Turn the cable adjusting nuts until the tire is
straight and tighten locking nuts.
M - SEAT ADJUSTMENT (Figure 16)
1. There is a total fore-aft adjustment of 2"
(51mm).
2. Remove the 1.2-13 nut (A) holding the seat
plate to the seat spring and adjust as needed.
PTO BELT GUIDE ADJUSTMENT (Figure 17)
Adjust belt guides shown as follows:
POINT "A" - 1/4-3/8" (6-10 mm)
POINT "B" - 1/8-1/4" (3-6 mm)
POINT "C" - 1/8-1/4" (3-6 mm)
GB