Programming Example - Fermax Vds-Bus2-Duox System Programmierungshandbuch

VDS - B VDS - B VDS - BUS2 - DUO VDS - BUS2 - DUO VDS - B VDS - B VDS - B VDS - B US2 - DUO US2 - DUOX X X X X US2 - DUO US2 - DUO US2 - DUO US2 - DUOX X X X X US2 - DUO
VDS - B VDS - B US2 - DUO

PROGRAMMING EXAMPLE

Example: Programming call code of 14th C (14th floor - apartment C).
1. Programming apartment terminal: monitor or telephone.
This address line must be programmed (it will be stored in the telephone memory) for
instance with the number '42' (this number must be lower to 199 and it is also
recommended to program telephones and monitors with consecutive codes). Program
the address line according to Installation Manual.
This code is the call code to stablish connection with the 14th C apartment from a
pannel without Display. The call will be made on entering: '42     '.
REMARKS:
    
Every apartment terminal must be programmed with the same programming
process (no panel model dependance).
    
In panels without Display the programming process ends at this point.
    
Panels with Display provide two additional modes to make a call:
- entering a call code (not necessary equal to the one stored in apt. terminal).
- searching with navigation arrows and pressing  to make the call.
2. Programming the "call code" Panels with Display module:
+ AB21AB + 24797
Pag 34
Programming menu
Users menu
1
(+) Add user