Coltech RP120W Original Bedienungsanleitung Seite 7

Troubleshooting
Problem Possible cause
The floodlight is Power cut, blown fuse,
not activated by light switched off.
movement in the
Blown bulb.
detection zone.
The area is too light.
The control dial/s is/are
set wrong.
The sensor is
aimed wrong.
The floodlight Heat from the floodlight
comes on for housing is activating
no reason. the sensor.
Heat sources, lighting
or cars are activating
the sensor.
Wild animals/birds, pets
activating the sensor.
Interference from
other machinery on
the same phase.
Reflections from
swimming pool or other
reflecting surface.
The floodlight Lights all the time.
does not go off.
Lights too long.
The floodlight The [LUX] dial is set on
comes on during daylight (Sun).
the day.
Remedy
Check the connections,
fuses, switches.
Inspect, replace.
Alter the direction of the sensor,
move the sensor.
Adjust the angle of the sensor or
adjust the control dial.
Alter the direction of the sensor or
adjust it.
Adjust it. The min.distance between
the floodlight and the sensor must
be 40 mm.
Direct the sensor head away from
the sources of interference.
Changing the direction of the sensor
head can help.
Try this: Replace blown fuse,
replace fluorescent tube and/or
reactor and starter.
Point the sensor in another direction.
Pointing the sensor in another
direction might help.
Reduce the setting using
the [TIME] dial.
Adjust the [LUX] setting and test it.
7