Coltech RP120W Original Bedienungsanleitung Seite 4

Installation
1. Important: Read the entire instruction manual before installation. The installation
should be carried out by a qualified electrician and conform to current regulations.
2. Warning! Make sure that the power is turned off and that the fuse is removed
before beginning any installation, change of light bulb or service.
3. Remove the wall bracket.
4. Using the bracket as a template, mark the position of the screw holes. Drill the
holes in the wall where the light is to be mounted. Use suitable screws and wall
plugs if necessary. The floodlight must be fixed securely. Mount the floodlight
horizontally (± 4°) (Fig. 3A).
5. Remove the cover of the
junction box, remove the
cable gland and strain
relief, feed in the power
cable (3G 0.75) through the
gland and rubber grommet.
Connect the three wires of
the cable to the terminal
block (Fig. 2B).
6. Replace the terminal block, cable strain relief, cable gland and cover.
Tighten the screws.
7. Undo the screws in the lamp cover and open it. Insert a light bulb between the
spring-loaded holders. Close the lamp cover and tighten the screws.
Bear this in mind when changing light bulbs: Let the bulb cool before removing it,
do not touch it with your fingers and make sure that all the lamp cover seals are intact.
Lamp Cover Screw
Gland
Cable Strain Relief
Power Cable
Lock Nut
Terminal Block
Wall Bracket Screws (2 pcs)
Junction Box Cover
Screws (4 pcs)
Wall Bracket
White (lamp wire)
Earth
N (neutral)
L (live phase)
4
Fig. 2A
Black (sensor wire)
Yellow/Green (lamp wire)
White (lamp wire)
Blue (sensor wire)
Brown (sensor wire)
Fig. 2B