Technical Specifications - Coltech Rp120W Original Bedienungsanleitung

Setting the motion detector (Fig.4)
1. Set the [LUX] dial to Sun, let the sensor stabilise for half a minute, make sure
that the [TIME] dial is set on minimum (-). The floodlight will now activate for
30 seconds (this will happen within 1 minute).
2. Point the sensor towards the area you wish to scan.
3. Ask a friend to pass through the detection zone, carefully adjust the angle of
the sensor arm until the floodlight is activated by your friend (see Fig. 1B).
4. Adjust the operating time using [TIME] until it is set to your wishes.
5. If you just want the light to come on in the dark, adjust the light sensitivity by
turning the [LUX] dial from Sun to Moon. If you want the light to come on at dusk,
wait until the light level has fallen to the desired level and then slowly turn the [LUX]
dial towards the Sun symbol whilst having a friend walk across the detection zone.
Turn the dial until the floodlight comes on. This procedure sometimes needs to be
repeated before the correct setting is found.
Important! When adjusting the angle of the floodlight, make sure that its housing
does not come too close to the sensor, the heat from the light might interfere with
the sensor. Wipe the lens of the sensor with a damp cloth a few times a year but never
open the sensor casing it could be damaged and the guarantee would become void.

Technical specifications

Max. range
Operating Time
Type of sensor
Mains supply
Power Consumption
Max power consumption
Protection Class
Disposal
Follow local ordinances when disposing of this product.
If you are unsure about how to dispose of this product contact your municipality.
12 metres at 180° scanning angle
(10±5 seconds) to (4±1 minutes)
Infra-Red (PIR)
230 V AC, 50 Hz
4 W (sensor alone)
400 W for RP400W and 120 W for RP120W
IP44 (approved for outdoor use)
6