Coltech RP120W Original Bedienungsanleitung Seite 5

8. Fix the light to the wall bracket; tighten all screws and lock nuts.
Position the floodlight in the desired place.
9. Replace the fuse and adjust the light pattern.
Important! Undo lock nuts and screws before adjusting the angle of the light.
Warning: This light must NOT be directed at flammable surfaces (Fig. 3B,C).
+/-4 degrees
Fig. 3A
Controls
• Operating time after activation the illumination time can be adjusted from (10±5
seconds) to (4±1 minutes), this time is altered by turning the [TIME] dial + or –.
Note! Each time the detector senses a movement the operating time starts again.
• The light sensitivity needed for activation is measured by a photocell which
differentiates between light and dark. Adjust it by turning the [LUX] dial from Sun
to Moon. Sun is used during the day until nightfall; Moon is only used at night,
in the dark.
• The motion sensitivity is controlled by the [SENS] dial, which alters the distance
needed between the sensor and the motion in order to activate the light.
Turn the dial towards the (+) to increase the distance needed, and the opposite
way to lessen the distance needed to activate the light.
Fig. 4
At least 90 degrees
Fig. 3B
5
At least
20 cm
At least 1 m
Fig. 3C