PROLED Smart DMX Bedienungsanleitung Seite 7

Smart Controller DMX
3. Control buttons
In StandAlone operation programs are selected and controlled with six buttons on the front
side of the controller. The functions are described as listed below.
On / off button. By pressing this button the LED's can be switched on and off at any
time. In off state the display shows p***, where *** corresponds to the IC-number (HL
1606 LED module).
Play / pause button. With this button you can stop and start the colour changing
programs. In pause state the DMX address can be modified; the display shows C***,
where *** corresponds to the current DMX address.
Add button. By pressing this button the clolour changing speed is increased. When
the LEDs are switched off, this button is used to increase the IC number (HL 1606);
the maximum value is 255 (510 RGB LEDs). In pause state this button is used to
increase the DMX address; the maximum value is 999.
Minus button. By pressing this button the clolour changing speed is decreased. 100
speed levels are selectable. When the LEDs are switched off, this button is used to
decrease the IC number (HL 1606); the minimum value is 16 (32 RGB LEDs). In
pause state this button is used to decrease the DMX address; the minimum value is
1.
Program selection button, downward.
Program selection button, upward. 83 programs are availabe altogether.
Functions of the remote control:
On/Off: With this button you can switch the LEDs on and off. In off state the display shows
p*** , where *** corresponds to the IC-number.
Pause: With this button you can start and stop the programs. In pause state the DMX
address can be modified; the display shows C***, where *** corresponds to the current
DMX address.
S+: By pressing this button the clolour changing speed is increased. When the LEDs are
switched off, this button is used to increase the IC number; the maximum value is 255 (510
RGB LEDs). In pause state this button is used to increase the DMX address; the maximum
value is 999.
S-: Bei By pressing this button the clolour changing speed is decreased. When the LEDs
are switched off, this button is used to decrease the IC number; the minimum value is 16
(32 RGB LEDs). In pause state this button is used to decrease the DMX address; the
minimum value is 1.
M+: Program selection button, downward.
M-: Program selection button, upward.
info@proled.com 7
PROLED
www.proled.com