Ronix RP-0181 Bedienungsanleitung Seite 28

- Lock the lever of the trigger gun.
OPERATION
ATTENTION!
Dry running of more than 2minutes leads to damage to the
high-pressure pump. If the appliance does not build up pressure within
2 minutes, switch the appliance off and proceed in accordance with the
instructions in Chapter "Troubleshooting".
HIGH-PRESSURE OPERATION.
CAUTION!
Keep a distance of at least 30cm when using the jet for cleaning painted
surfaces to avoid damage.
CAUTION!
Make sure the on/off switch is set to the "OFF/ON" position and insert
the plug into a properly installed socket.
ATTENTION!
- The washer must be used on a secure and stable surface in a
standing, upright position.
Connect the product to power and the power supply as described.
- Open the water supply
- Hold the spray gun with both hands.
- Direct the nozzle of the chosen accessory away from you towards the
surface to be cleaned.
- Unlock the trigger and press it until a constant amount of water flows
through the nozzle, to allow air trapped in the hose to escape.
26
Induction high Pressure Washer