Dismantling Instructions - Toors Indy Gt-R Sl Montageanleitung

Installation manual / Manuel d'installation / Montageanleitung / Návod na montáž / Installations manual
• Modifying or removing functional parts may put important safety components out of action. Uncontrolled door
movement could occur and persons or objects may be trapped and injured as a result.
• Do not modify or remove any functional parts.
• Do not attach any additional parts. The torsion springs are precisely matched to the door leaf weight. Additional
components may overload the springs.
• If equipping the door with a motor operator, pay attention to the instructions provided by the manufacturer of the motor
operator. Only use the original connections of the door manufacturer!
Before installing the door, the door opening and the building floor must be completely finished.
Observe the following regulations during the installation:
ome parts can have sharp edges. Use protective gloves.
Never use the sectional door in case of visual damage on the safety devices.
Make sure you can always perform your work in a stable environment.
Make sure there is enough light.
When performing assembly or maintenance, always wear at least gloves and safety boots.
When drilling or cutting always wear safety goggles.
Only use appropriate tools, especially when applying tension to torsion springs.
Provide for adequate water run-off in the area of the bottom seal and the frame parts.
To ensure simple and safe assembly please follow the work steps listed in the illustrated section.
• Springs are under high torque stress and may discharge high forces if they are not secured during tensioning. Fix the door
leaf to prevent movement before tensioning the springs.
• When the springs are tensioned correctly, the moving door leaf has a slight tendency to pull upwards.
• Each time the door is maintained, the tension of the springs should be checked and, if necessary, subsequently
readjusted.
Pay particular attention while releasing the fixing. Make sure that no persons or objects are located in the way of the
doorleaf.
Dismantle the door can only be performed by qualified service organization, respectively by qualified service technician. Dismantle
the door is performed in the logically reverse order.
INSTALLATION GUIDE
! WARNING !
Danger of injury as the result of structural modifications
! WARNING !
Danger due to hight torque

DISMANTLING INSTRUCTIONS

3
SL