Flex JSP 12-EC Originalbetriebsanleitung Seite 16

Noise and vibration
The noise and vibration values have been
determined in accordance with EN 62841.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value:
– Emission value a
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The declared vibration total value(s) and
the declared noise emission level given in
this information sheet has been measured
in accordance with a measurement method
standardized in EN 62841 and may be used
to compare one tool with another.
It may be used for a preliminary assessment
of exposure. The specified vibration emission
level represents the main applications of the
tool.
However, if the tool is used for different
applications, with different cutting accessories
or poorly maintained, the vibration emission
level may differ.
This may significantly increase the exposure
level over the total working period.
To make an accurate estimation of the
vibration exposure level, it is also necessary
to take into account the times when the tool
is switched off or running but not actually in
use.
This may significantly decrease the exposure
level over the total working period.
Identify additional safety measures to
protect the operator from the effects of
vibration such as: maintain the tool and the
cutting accessories, keep the hands warm,
organization of work patterns.
WARNING:
The vibration and noise emissions during
actual use of the power tool can differ from
16
: 85 dB(A)
pA
: 93 dB(A)
WA
K = 5 dB
(cutting boards):
h
4.0 m/s
(cutting sheet metal):
h
3.0 m/s
K = 1.5 m/s
the declared value in which the tool is used;
In order to protect the operator, user should
wear gloves and ear protectors in the actual
conditions of use.
CAUTION!
Wear ear defenders at a sound pressure
above 85 dB(A).
Technical data
2
Tool
Type
2
Rated voltage Vdc
2
Speed
Stroke length mm
Cutting angle
(left/right)
Max.sawing
capacity
in wood
in aluminium
in metal
Weight
according
to"EPTA
Procedure
01/2003"
(without
battery)
Battery
Weight of
battery
Working
temperature
Storage
temperature
Charging
temperature
Charger
Overview (see figure A)
JSP 12-EC
Jig Saw
12
spm 800-3000
23
° 0°-45°
90
mm 20
10
kg
1.46
AP 12/2.5
12V AP 12/4.0
AP 12/5.0
AP 12/2.5
kg AP 12/4.0
AP 12/5.0
-10-40℃
< 50℃
4-40℃
CA 12/18, CA 12
JSP 12-EC
0.3
0.4
0.4