Hobbytech Spirit Evo RTR Bedienungsanleitung Seite 6

How to control Your model
If the wheels operate in the opposite direction, operate the servo reverse switch (ST in position NOR).
transmitter adjustment
Throttle Trim is used to slightly trim the throttle servo when the
trigger is at Neutral position.
Steering Trim is used to slightly trim the front wheels steering.
Note: If the front wheels are not straight when the trigger is set at
Neutral position, you can adjust the steering.
setting neutral
Max 1mm open!
6
left
Notice : please keep the
transmitter and receiver
from over 40cm distance
away, when you operate the
unit.
Throttle Trim
Steering Trim
If you are a reverse
operator, set the steering
and / or throttle switch to
REV. Position first.
setting full tHrottle
❶
Carburator max open!
neutral
rigHt
low BatterY led
When the green indicator starts flashing, replace the batteries
with new ones as soon as possible
Do NOT operate when transmitter and/or receiverbatteries are
low or else the control of the model will be lost.
tHe setting of receiVer
witH fail safe performance
1. Please press the TH, ST switch of transmitter to the normal control
position. Turn on the transmitter and turn on the receiver at the
same time, the LED on the receiver will be bright all the time.
2. The LED on the receiver becomes fast flashing if you press the
F/S SET.
3. Put the transmitter's throttle wheel to the brake degree which you
want, press the F/S SET on the receiver, the red LED will be bright
all the time, then the setting is over.
4. Please put the throttle wheel on
the neutral position when you use
it on the electric car.
5. The vehicle will stay on neutral (no
speeding up, no braking) when
you close the transmitter.
❷
setting full Brake
Max 1mm open!
❸