Simple Audio Roomplayer Schnellstartanleitung Seite 9

Add another Roomplayer to make a multi-room
You can add multiple Roomplayers
First, make sure that your current Roomplayer
steps one, two and three below.
STEP 1
Connect any equipment to your new Roomplayer
Before you power on your Roomplayer, connect
adding a new Roomplayer, connect it to your amp or HiFi with the RCA cable. f you are
adding a new Roomplayer with Amp, connect
plug sockets.
This is also a good time to connect
STEP 2
Prepare your new Roomplayer
Plug in and power on your new Roomplayer
button and hold it down until the green LED on the front flashes. This will take
approximately 12 seconds. The green LED will go out when you release the button.
STEP 3
Connect your new Roomplayer
Get ready to connect your new Roomplayer to your network. There are two ways to do
this, and both options are explained here. Just make sure that all your Roomplayers
powered on.
system
to make a multi-room music streaming system.
system is up and running, then follow
all your audio equipment.
it to your speakers using the spring or
any additional equipment,
or Roomplayer with Amp. Press the pairing
to your Roomplayer network
If you are
like a subwoofer or TV.
are
OPTION
Use an Ethernet Cable to connect your
new Roomplayer or your new
Roomplayer with Amp to your router.
Plug one end of the Ethernet cable into
your new Roomplayer and the other end
into your router. That's it.
Check that it is connected:
The red LED on the front of your new
Roomplayer will go out, which means
that your new Roomplayer is now
connected to your network and it will be
visible on all your Simple Audio apps.
WET,'
8