Simple Audio Roomplayer Schnellstartanleitung Seite 10

OPTION
f you don't want to use an Ethernet cable to connect your new Roomplayer
Roomplayer with Amp to your network, you can use the Roomplayer
instead. Here's how:
Activate your existing Roomplayer
Go to any network connected
its pairing button for 2 seconds only. When you release the button the green LED on the
front will start flashing. This means that this existing Roomplayer
Roomplayer to join its network
Ono
Now, activate your new Roomplayer
You want to accept this invitation, so go to your new Roomplayer, then press and hold
its pairing button for 2 seconds only. When you release the button, the green LED on the
front will start flashing and this means that your new Roomplayer
Check that it is connected
The green LED's on both Roomplayers
paired, and the red LED on the front your new Roomplayer
connected to your network. Your new Roomplayer will also be visible on all of your
Simple Audio apps.
first
Roomplayer that you have already set up. Press and hold
PAIRING BUTTON
.GREEN PAIRING LED
-RED LED
will stop flashing when they have successfully
or your new
pairing buttons
is inviting your new
is accepting the invite.
will go out to show that it is
Troubleshooting
If you experience any difficulties whilst
setting up your Roomplayer
contact your local retailer, or visit
simpleaudio.com/support
where you can find answers to
commonly asked questions.
You can also contact the
Simple Audio support team via
support@simpleaudio.com
Please also note that this Quick
Guide is available in additional
languages on the Simple Audio website.
please
Start