Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DORELLA L8 – DORELLA L12
The heating of the environment is made by:
•
Convection: (70%) the air passage through the double mantel of the stove releases heat into
the environment;
•
Irradiation (30%): through the panoramic glass and the external hot surfaces of the stove, the
heat is radiated into the environment.
The stove is equipped with controls of primary and secondary air by
which it is adjusted the combustion air.
(see chapter 10).
2.1.
PRIMARY AIR CONTROL (movable valve)
With the primary air control (movable valve), which is found below the
hearth door it is adjusted the passage of air through the ash drawer
and the grate in the fuel direction (Picture 1 pos.A). The primary air is
necessary for the combustion process. The ash drawer must be
regularly emptied, so that the ash does not obstruct the primary air
entry. Through the primary air the fire is also kept alive.
During wood combustion, the register of primary air must be opened
only for a while, because otherwise the wood burns fast and the stove
may overheat.
2.2.
SECONDARY AIR CONTROL
On the inferior part of the door there is the secondary air control
(Picture 1 pos. B). Also this register must be opened (then moved to
the left), especially for wood combustion.
3.
RULES FOR INSTALLATION
The stove, assembled and ready for the installation, must be connected with a junction to the existing flue
of the house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The
connections must be tight.
It is obligatory to respect the National and European rules, local regulations concerning building
matter and also fireproofs rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular
attention to windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for
the connection must correspond at least to the diameter of the smokes pipe. The opening should be
equipped with a wall connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your floor can support the weight of the stove (for ex. distributing weight plate).
LA NORDICA is not responsible in case of modification of the product and for the use of not
original spare parts.
THE HEARTHS MUST NOT BE MODIFIED.
4.
FIRE SAFETY
In the installation of the stove the following safety measures are to be followed:
a) In order to ensure sufficient thermal insulation, respect the minimum safety distance from objects or
furnishing components flammable and sensitive to heat (furniture, wood sheathings, fabrics. etc.) and
from materials with flammable structure (see (Picture 2 - A). All the minimum safety distances are
shown on the product data plate and lower values must not be used.
b) in front of the chimney stove there must not be any flammable object or building material, sensitive to
heat, at less 100 cm's. of distance. This distance can be reduced to 40 cm's if you will install in front of
the element to protect a retro ventilated and heat resistant protection.
c) If the product is installed on a non totally refractory floor, one must foresee a fireproof background. The
floors made of inflammable material, such as moquette, parquet or cork etc., must be replaced by a
layer of no-inflammable material, for instance ceramic, stone, glass or steel etc. (dimensions according
1191032 – Rev.06 – EN
B
A
Picture 1
17
Werbung
Inhaltsverzeichnis
