Elinchrom Digital 1200 RX, Digital 2400 RX Gebrauchsanleitung Seite 8

Slow Charge (3)
The green LED indicates that the slow charge function is selected.
This position is recommended if the mains line capacity is limited for the standard
fastcharge mode.
Open Flash (5)
When the green LED is illuminated the flash may be released manually.
The release is blocked during charging, but not when the unit discharges.
The integrated discharge system is protected by a thermic cut out.
In order to restrict the heating of the unit, we suggest to release a flash with the
green touch (5) "READY" after each strong reduction of power (more the 2f-stop).
This allows to release the excess of energy in the flash tube.
You will gain time and extend the life span of your power packs.
Photocell On/Off (6)
The Photocell (8) is activated when the green LED (4) is illuminated. When switched
on, the pack can be remotely triggered by another flash unit! The Digital RX photocell
is specially designed to work under ambiant light situation in your studio, direct light
or other strong lights may reduce the sensitivity of the cell. In difficult situations e.g.
blinding, sunlight or obstacles, the additional cell with 5 m cord (extensions available)
solves most problems.
Charge Ready Beep (9)
Press this touch (9) to activate the acoustic signal
Once recycled, an acoustic signal (beep) indicates that the power pack is ready.
Synchronisation Socket
Standard / Elinchrom Amphenol socket or 3.5 mm mini-jack (10).
N.B. Do not link ELINCHROM power packs via sync cable to other brands.
ELINCHROM uses low voltage (5V) for security reasons. Other systems may have
higher voltages and could cause damages.
Flashheads Control button
These buttons switches on the flashhead sockets.
8