Flashheads; Safety Precautions - Elinchrom Digital 1200 Rx, Digital 2400 Rx Gebrauchsanleitung

Flashheads

When plugging in a lamphead connector, first push in the front part, then firmly press in the
whole plug, the rear part being secured by the locking spring.
!
Do NOT plug in or unplug lampcords
while the green leds on output A and B
are ON (illuminated)
Halogen modelling lamp
Use only the recommended modelling lamp, the Digital S and Digital SE heads
are fitted with a 300 W halogen modelling lamp. For 230 V code 23022.
Protective Pyrex Dome
For use with standard halogen lamp GX 6.35 socket.
Transparent, matt or yellow (400° K colour correction), can be fitted to all lampheads, except
R heads for which clear or matt security filters are available.
Easy attachment of the protective dome:
• Disconnect the lamphead from the pack
• Loosen the 3 screws of the lamphead reflector
• Fit the clips underneath the screw heads and tighten the screws
• Put the dome in place and hook the springs into the airvent holes.

Safety Precautions

• The flashheads cannot be insulated against humidity and dust.
• Do NOT plug in or unplug lampcords while the green leds on output A and B
!
are ON (illuminated).
• Never store liquids or drinks on the power pack panel or closed to the unit!
• Do not use near flammable/explosive material (min. 1m distance of any object)
• For your safety, use only Elinchrom flashheads.
• Do not open the unit. In the event of damage or apparent failure, contact a
repair service or any Elinchrom agent or email: Elinchrom@Elinchrom.ch
10
2
1
Socket
Protective dome