Digital Power Display; Functions - Elinchrom Digital 1200 Rx, Digital 2400 Rx Gebrauchsanleitung

Operating Instructions
Before connecting the digital RX for the first time, make sure that your mains supply and the
rating set on the equipment (electrical specification plate) are compatible to 110V or 230V.
• Connect lampheads ensuring that lamphead touches (18-19) are Off.
• Connect the mains cord in the inlet socket (1)
• Select charging rate (11) ("
• Select modelling lamp setting (4)
• Connect the synchro lead (10)
• Check that the photocell's switch (6) is in the required position.
• Use the touch buttons (12 - 13) to select the desired power.
• The open flash (5) will light up, indicating that the unit is ready for operation.
Fonctions
On/Off Switch (1)
By pressing this touch button the Digital RX is switched on or off.
This unit is protected by a thermal circuit breaker to avoid overheating. Should this
occur, the unit turns off automatically and cannot be operated! After a break for
cooling, the flash is ready again for operation.

Digital Power Display (14)

The actual flash power is displayed in a f-stop compatible format. The power
range is 6 f-stops. The digital display, provides continuous power indication
of the flash and modelling lamp. The controls cover a continuous output
range from full power 1/1 to 1/32th in 1/10th f-stop steps. During charging or
discharging the display "flashes". In case of overheating or malfunction, the
display shows "ER" for error.
Digital Power Regulation (12 and 13)
The power control provides simultaneous and continuously variable adjustment
of the modelling lamp and the flash power in step of 1/10 f-stop. The display,
provides digital power information, in f-stop from 3.5 to 8.5 for the "Digital
2400 RX" and 2.5 to 7.5 for the "Digital 1200 RX".
Modelling Lamp Controls (4-16-17)
• Proportional: The modelling lamp will be adjusted automatically in proportion, when
the flash power is set to another value with touch button 12 or 13.
• Free: To set flash- and modelling lamp values individually.
• Modelling Lamp off
Note: There is an additional ON/OFF switch for the modelling lamp at the flashhead!
The flashhead control button A/B must be switched on for the selected flashhead.
" slow position), only when the mains supply is too limited.
EN
7