Installation - Hotpoint Ariston MR 940.3 (OW) Bedienungsanleitung

- If the appliance breaks down or functions poorly; ask
for original spare parts.
It is a good idea to do the following:
- Only use the appliance to cook food, nothing else;
- Check the soundness of the appliance after it has been
unpacked;
- disconnect the appliance from the electrical mains if it
is not functioning properly and before cleaning or
performing maintenance;
- When the appliance is not used for an extended period
Important: The power supply to the appliance must be cut
off before any adjustments or maintenance work is done
on it.
Installation of Built-in Ovens
To ensure the proper working order of the built-in appliance,
the kitchen unit must be of a suitable size.
The sizes of the unit for installing the cooker under a
worktop or in a column unit are shown in figure.
To provide adequate ventilation, there must be appropriate
ventilation openings in the front bottom and the top part of
the cabinet (an intake opening on the bottom of at least
200 cm 2 , and an exhaust opening of at least 90 cm
The unit panels next to the cooker must be heat resistant.
In the case of veneered wood units, glues must be resistant
to a temperature of 120 °C.
In accordance with safety standards, once the appliance
has been mounted, there must be no possible contact with
electrical parts. Any protective parts must be secured so
that they can only be removed with the use of tools.
of time, cut off the supply of power and close the gas
cock (if present);
- Use cooking gloves to place cookware in the oven or
when removing it;
- Always grasp the oven door in the centre because the
ends may be hot due to the escape of hot air;
- Make sure that the control knobs are on the
setting when the appliance is not in use;
- Cut the power supply chord after disconnecting it from
the mains when you decide not to use the appliance
any longer.

Installation

2) .
Fastening the oven
Before inserting the oven into the cabinet, loosen the 4
rear screws "D" - which fasten the side panels - if necessary.
This will make it easier to move the oven vertically. The
oven should be fastened to the cabinet through the 4 holes
situated on the frame, using the screws and spacers
provided. Once the oven has been fastened to the cabinet
by inserting and screwing the screws in holes "A" tightly,
proceed as follows:
1) With the oven door open, loosen the six screws "C"
(this way the side panels can slide down);
2) Lower the side panels as much as necessary to gain
access to the 2 holes "B" to fix the oven permanently;
3) Put the side panels back in place and fasten the 6
screws "C" tightly.
15
/